Even Water Distribution – Kuul Evaporative Technologies Best Practices

Even water distribution is vital for system performance. Kuul evaporative media supports air velocities up to 700 feet per minute without carryover. If exceeded, a drift eliminator cassette captures any potential for expelled water droplets up to 800 feet per minute. Let’s look inside and see the proper configuration for effective water distribution.

At the top of the unit are the water inlet pipe, umbrella bonnet header, umbrella spray bar pipe, and distribution media. The header assembly should be positioned at the center of the distribution media, with the umbrella bonnet touching the media itself. The umbrella spray bar pipe has 3/16-inch holes that are two inches apart from one another. This area is where the water exits, and these holes are positioned upwards at precisely 90 degrees to ensure proper water flow and even umbrella distribution.

The umbrella bonnet design supplies even water dispersion to the distribution media. The header ensures the airflow and water only pass through the media, preventing airflow and water from escaping into the system or unit.

The water enters the distribution media, which expands and distributes evenly. The water enters the media and flows downward at a 45-degree angle to the air-entering edge as the airflow passes through the evenly saturated media at a 15-degree angle. The entering air undergoes a temperature drop through the process of evaporation, thus providing cooling to the space.

For more information, on Portacool solutions, visit thekuuleffect.com.